Operating instructions/Installation instructions

Problem solving guide
76
Problem Cause and remedy
The brew unit cannot be
removed.
The brew unit is not positioned correctly.
 If necessary, move the handle on the brew unit
back to the start position. Close the machine door.
 Switch the coffee machine off.
 Wait approx.1minute before switching the coffee
machine back on.
This will initialise the brew unit motor and put it back
into the start position.
 If necessary, repeat these steps.
Coffee dispensing is re-
peatedly interrupted
and the message Fill the
bean container appears in
the display.
This is not a fault.
The brew unit has not detected the ground coffee.
Certain types of coffee produce a small amount of
coffee when they are ground. In such cases, the
grinder is usually set to fine and the minimum
quantity of coffee is set.
 Confirm the message withOK.
If the display appears with all types of coffee:
 Set the grinder to a coarser setting (see “Grinder
setting”).
 Select a larger quantity of coffee.
Don’t forget to check any drinks changed in
“Profiles”.
If the message only appears when dispensing certain
drinks:
 Check the quantity of coffee set for this drink (see
“Quantity of coffee”). Select a larger quantity of
coffee.
 You may also need to set a coarser grinder setting.
Drink dispensing is pre-
maturely aborted even
though there is a con-
tainer under the central
spout.
This is not a fault.
If the container has a very wide opening that
prevents the cup rim sensor from making contact
with the edge of the container (e.g. in the case of a
very large cup), the drink will be cancelled. Use a
different container or position the existing one so
that the sensor can detect the rim.