Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the appliance
- Controls and indicators
- Operation
- Before first use
- Filling the coffee bean container
- Filling the water tank
- Switching on and off
- Dispenser adjustment
- Preparing beverages
- Expert Mode
- Grinder setting
- Parameters
- Profiles
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Cleaning the drip tray and grounds container
- Cleaning the drip-tray cover
- Water container
- Cleaning the main dispenser
- Cleaning the cup-rim sensor
- Cleaning the milk flask with lid
- Cleaning the milk valve (daily)
- Removing and cleaning the milk valve (once a month)
- Cleaning the bean containers
- Cleaning the interior, inside of the machine door, and drip tray
- Cleaning the front of the machine
- Maintenance programs
- _
- _
- Cleaning the milk pipework
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Frequently Asked Questions
- Service and warranty
- Accessories
- Caring for the environment
- Installation
- FCC Declaration of Conformity
Installation
*INSTALLATION*
88
Building in the coffee machine
Danger of injury due to incorrect
operation.
A machine that has not been built in
is not safe and can cause injuries.
Do not operate the coffee machine
unless it has been built in.
Danger of damage due to
incorrect operation.
If the ambient temperature range is
not observed, the coffee machine
may not function properly.
The coffee machine may only be
operated within an ambient
temperature range of +60°F to
+100°F (+16°C to +38°C).
A minimum installation height of
33 7/16"(850mm) must be observed.
A door opening angle of 120° must
be ensured so that you can remove
the left-hand bean container.
Check that there is a gap of at least
113/4" (299mm) between the wall (or
similar) and the coffee machine so that
you can open the door wide enough to
remove the left-hand bean container
(minimum door opening angle of120°).
To install the machine, you will need a
TX20 screwdriver.
Removing transport restraint
1 screw hole is fitted with a red silicone
plug to protect the appliance against
transport damage and secure the door
during transport.
Remove the plug before screwing
the coffee machine to the cabinet
unit.
Pull firmly on the red silicone plug to
remove them from the screw holes.
The plug is not required for any other
purpose. Dispose of its with your
household waste.