Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the appliance
- Controls and indicators
- Operation
- Before first use
- Filling the coffee bean container
- Filling the water tank
- Switching on and off
- Dispenser adjustment
- Preparing beverages
- Expert Mode
- Grinder setting
- Parameters
- Profiles
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Cleaning the drip tray and grounds container
- Cleaning the drip-tray cover
- Water container
- Cleaning the main dispenser
- Cleaning the cup-rim sensor
- Cleaning the milk flask with lid
- Cleaning the milk valve (daily)
- Removing and cleaning the milk valve (once a month)
- Cleaning the bean containers
- Cleaning the interior, inside of the machine door, and drip tray
- Cleaning the front of the machine
- Maintenance programs
- _
- _
- Cleaning the milk pipework
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Frequently Asked Questions
- Service and warranty
- Accessories
- Caring for the environment
- Installation
- FCC Declaration of Conformity
Frequently Asked Questions
Problem Possible cause and solution
Check water intake and
empty the water container
The plumbed-water supply is not working.
Check whether the intake hose is kinked or the
water supply valve is not turned on completely.
Remove and empty the water container.
Insert the empty water container into the coffee
machine.
The following message is displayed: Please wait.
Water container is being filled. The water container fills
up.
To turn off the plumbed-water connection, fill and
insert the water container. You can then select
Settings : Water connection| Off.
F233 The cup-rim sensor is not inserted or is incorrectly
inserted.
If the main dispenser is moving upward and the cup-
rim sensor is bumped, e.g., with a cup, the cup-rim
sensor loses its reference position.
Confirm the message withOK.
Reinstall the cup-rim sensor.
Cup-rim detection remains inactive and the main
dispenser stays in the top position until the coffee
machine is next switched on. Cup-rim detection is
reinitialized during the next switch-on operation.
F307or Remove the milk
valve and clean it
The milk valve is faulty.
Remove and clean the milk valve (see “Cleaning
and care – Removing and cleaning the milk valve”).
73