Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the appliance
- Controls and indicators
- Operation
- Before first use
- Filling the coffee bean container
- Filling the water tank
- Switching on and off
- Dispenser adjustment
- Preparing beverages
- Expert Mode
- Grinder setting
- Parameters
- Profiles
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Cleaning the drip tray and grounds container
- Cleaning the drip-tray cover
- Water container
- Cleaning the main dispenser
- Cleaning the cup-rim sensor
- Cleaning the milk flask with lid
- Cleaning the milk valve (daily)
- Removing and cleaning the milk valve (once a month)
- Cleaning the bean containers
- Cleaning the interior, inside of the machine door, and drip tray
- Cleaning the front of the machine
- Maintenance programs
- _
- _
- Cleaning the milk pipework
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Frequently Asked Questions
- Service and warranty
- Accessories
- Caring for the environment
- Installation
- FCC Declaration of Conformity
Frequently Asked Questions
Problem Possible cause and solution
F73 or
Check the brew unit
The brew unit cannot be positioned correctly or is
soiled. It is not possible to press the ground coffee.
Check whether you can remove the brew unit.
If you can remove the brew unit, rinse it under
running water.
Push the coffee ejector of the brew unit into the
correct position (see image).
Replace the water container in the coffee machine
and close the door. Do not insert the brew unit.
Switch the coffee machine on.
This will initialize the brew unit motor and put it back
into the start position.
When Insert the brew unit appears in the display, put
the brew unit back in the coffee machine. Close
the machine door.
If you cannot remove the brew unit, switch the
coffee machine off. Wait for
approximately2minutes before switching the
machine back on again.
A maintenance program
is prematurely aborted
and the following ap-
pears in the display:
Push the water container in
until it engages.
The water container has not been filled and inserted
correctly.
Check that you have selected the correct mark.
The symbols marked on the water container indicate
the amount of water required for the
Descale the appliance: and Clean milk pipework:
maintenance programs.
Fill the water container up to the relevant mark and
restart the process.
72