Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the appliance
- Controls and indicators
- Operation
- Before first use
- Filling the coffee bean container
- Filling the water tank
- Switching on and off
- Dispenser adjustment
- Preparing beverages
- Expert Mode
- Grinder setting
- Parameters
- Profiles
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Cleaning the drip tray and grounds container
- Cleaning the drip-tray cover
- Water container
- Cleaning the main dispenser
- Cleaning the cup-rim sensor
- Cleaning the milk flask with lid
- Cleaning the milk valve (daily)
- Removing and cleaning the milk valve (once a month)
- Cleaning the bean containers
- Cleaning the interior, inside of the machine door, and drip tray
- Cleaning the front of the machine
- Maintenance programs
- _
- _
- Cleaning the milk pipework
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Frequently Asked Questions
- Service and warranty
- Accessories
- Caring for the environment
- Installation
- FCC Declaration of Conformity
Cleaning and care
62
Connect together the angular molded
hose and longer milk pipework. Start
by attaching the top of the molded
hose to the main dispenser. The
black connecting piece should be
pointing to the rear.
Then, connect the bottom end of the
molded hose to the dispensing unit.
Insert the milk pipework into the milk
valve on the left and right-hand sides.
Push the connecting pieces into the
silicone seal as far as they will go.
Check that the milk pipework is snug
against the housing and that the
cover can be easily attached.
Tip: If necessary, screw the milk
pipework backward at the connecting
piece on the right-hand side.
Attach the milk-valve cover as
follows: insert the pin in the top right-
hand corner and swivel the cover
backward until a proper fit is
achieved.
Push the left-hand bean container
and maintenance container back into
the coffee machine. Attach the main
dispenser’s stainless-steel cover.
Close the appliance door.