Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Guide to the machine
- Controls and indicators
- Operation
- Miele@home
- Before using for the first time
- Filling the coffee bean container
- Filling the water container
- Switching on and off
- Spout adjustment
- Making drinks
- Expert mode
- Grinder setting
- Parameters
- Profiles
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Cleaning by hand or in the dishwasher
- Unsuitable cleaning agents
- Cleaning the drip tray and waste container
- Cleaning the drip tray cover
- Cleaning the water container
- Cleaning the central spout
- Cleaning the cup rim sensor
- Cleaning the milk flask with lid
- Cleaning the milk valve (daily)
- Removing and cleaning the milk valve (once a month)
- Cleaning the bean containers
- Removing the brew unit and cleaning it by hand
- Cleaning the interior, inside of the machine door and drip tray
- Cleaning the front of the machine
- Maintenance programmes
- _
- _
- Cleaning the milk pipework
- Degreasing the brew unit and cleaning the interior
- Descaling the machine
- Problem solving guide
- After sales service and warranty
- Accessories
- Installation
- Technical data
- EU Conformity declaration
- UK Conformity declaration
Settings
45
Eco mode
Eco mode is an energy-saving mode.
The system does not heat up until
someone starts making a drink.
Barista mode
This performance mode has been
optimised for unadulterated coffee
enjoyment. Users can enjoy coffee-
based drinks without any delay as the
coffee machine remains heated to the
brewing temperature. This mode
consumes more energy than Eco mode.
Latte mode
This performance mode has been
optimised for preparing milk. Milk-
based drinks can be prepared within a
much shorter space of time. This mode
consumes more energy than Eco mode
and Barista mode.
Party mode
This performance mode has been
configured for the occasional intensive
use of the coffee machine, e.g. for
family get-togethers.
Clean the coffee machine thoroughly
after intensive use, particularly the
milk pipework. It may be necessary
to descale the coffee machine and
degrease the brew unit.
Please note the following information
about Party mode:
- The general pipework is rinsed much
less frequently or not at all. The milk
pipework is not rinsed until
around1hour after milk was last
dispensed.
- Cleaning status messages or
cleaning prompts are suppressed
and delayed until the machine is next
switched on.
- The Switch off at and Switch off after
timers are deactivated. The coffee
machine switches off 6hours after
the last sensor was pressed.
- The cup light remains permanently
switched on at the maximum
brightness level for as long as the
coffee machine stays switched on.
Water hardness
Programme the coffee machine to the
water hardness level of your area so
that it functions correctly and does not
get damaged.
Contact your local water supplier to find
out your local water hardness range if
necessary.
If you are using bottled drinking water,
e.g. mineral water, select settings
according to the calcium content. The
calcium content is specified on the label
of the bottle in mg/lCa
2+
or ppm
(mgCa
2+
/l).
Do not use carbonated water.
The hardness level is set to21°dH by
default.