Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the appliance
- Controls and indicators
- Operation
- Before first use
- Filling the coffee bean container
- Filling the water tank
- Switching on and off
- Dispenser adjustment
- Preparing beverages
- Expert Mode
- Grinder setting
- Parameters
- Profiles
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Cleaning the drip tray and grounds container
- Cleaning the drip-tray cover
- Cleaning the water container
- Cleaning the main dispenser
- Cleaning the cup-rim sensor
- Cleaning the milk flask with lid
- Cleaning the milk valve (daily)
- Removing and cleaning the milk valve (once a month)
- Cleaning the bean containers
- Cleaning the interior, inside of the machine door, and drip tray
- Cleaning the front of the machine
- Maintenance programs
- _
- _
- Cleaning the milk pipework
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Frequently Asked Questions
- Service and warranty
- Accessories
- Caring for the environment
- Installation
- FCC Declaration of Conformity
Frequently Asked Questions
Problem Possible cause and solution
A fan can be heard even
though no drinks are
being prepared and the
coffee machine is
switched off.
This is not a fault.
Once a drink has been dispensed or the machine
has been switched off, the internal fan will continue
to run until the interior is sufficiently dehumidified.
The brew unit cannot be
removed.
The brew unit is not positioned correctly.
If necessary, turn the handle on the brew unit back
to the start position. Close the machine door.
Switch the coffee machine off.
Wait approx.1minute before switching the coffee
machine back on.
This will initialize the brew unit motor and put it back
into the start position.
If necessary, repeat these steps.
Drink dispensing is pre-
maturely aborted even
though there is a con-
tainer under the main
dispenser.
This is not a fault.
If the container has a very wide opening that
prevents the cup-rim sensor from making contact
with the edge of the container (e.g., in the case of a
very large cup), the drink will be canceled. Use a
different container or position the existing one so
that the sensor can detect the rim.
74