Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the appliance
- Controls and indicators
- Operation
- Before first use
- Filling the coffee bean container
- Filling the water tank
- Switching on and off
- Dispenser adjustment
- Preparing beverages
- Expert Mode
- Grinder setting
- Parameters
- Profiles
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Cleaning the drip tray and grounds container
- Cleaning the drip-tray cover
- Cleaning the water container
- Cleaning the main dispenser
- Cleaning the cup-rim sensor
- Cleaning the milk flask with lid
- Cleaning the milk valve (daily)
- Removing and cleaning the milk valve (once a month)
- Cleaning the bean containers
- Cleaning the interior, inside of the machine door, and drip tray
- Cleaning the front of the machine
- Maintenance programs
- _
- _
- Cleaning the milk pipework
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Frequently Asked Questions
- Service and warranty
- Accessories
- Caring for the environment
- Installation
- FCC Declaration of Conformity
Cleaning and care
59
Open the appliance door.
Clean the milk valve with a damp
cloth/microfiber cloth.
Close the appliance door.
Removing and cleaning the
milk valve (once a month)
If the following issues occur during milk
preparation, the milk valve may be
blocked: only hot milk is dispensed
instead of milk froth, the milk sprays
out. Clean the milk valve more often if
necessary.
The milk-valve cover should only be
cleaned by hand.
Open the appliance door.
Remove the bean container and
maintenance container on the left-
hand side.
Remove the main dispenser’s
stainless-steel cover.
Remove the milk-valve cover: press
on the recessed grip to unlock the
cover.
On the top right-hand side of the
cover, you will find a pin for swiveling
the cover out.
1
2
3
Detach the milk pipework from the
dispensing unit on the main
dispenser and from the milk-valve
silicone seal( and).
Remove the milk pipework
connecting the milk valve to the main
dispenser.
Disconnect the angular molded hose
from the round hose. Rinse the hoses
thoroughly under running water.
Do not remove the connecting pieces
from the hoses.