Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the appliance
- Controls and indicators
- Operation
- Before first use
- Filling the coffee bean container
- Filling the water tank
- Switching on and off
- Dispenser adjustment
- Preparing beverages
- Expert Mode
- Grinder setting
- Parameters
- Profiles
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Cleaning the drip tray and grounds container
- Cleaning the drip-tray cover
- Cleaning the water container
- Cleaning the main dispenser
- Cleaning the cup-rim sensor
- Cleaning the milk flask with lid
- Cleaning the milk valve (daily)
- Removing and cleaning the milk valve (once a month)
- Cleaning the bean containers
- Cleaning the interior, inside of the machine door, and drip tray
- Cleaning the front of the machine
- Maintenance programs
- _
- _
- Cleaning the milk pipework
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Frequently Asked Questions
- Service and warranty
- Accessories
- Caring for the environment
- Installation
- FCC Declaration of Conformity
Cleaning and care
60
1
2
3
Detach the milk pipework from the
dispensing unit on the main
dispenser and from the milk-valve
silicone seal( and).
Remove the milk pipework
connecting the milk valve to the main
dispenser.
Disconnect the angular molded hose
from the round hose. Rinse the hoses
thoroughly under running water.
Do not remove the connecting pieces
from the hoses.
Press the retainers on the left and
right-hand sides of the milk-valve
holder and pull the holder forward to
remove it.
Take the holder and silicone seal
apart.
Pull the stainless-steel bolt upward
and out.
Clean the individual components of
the milk valve in the dishwasher.
Tip: If there are any dry milk residues
on the front, soak the stainless-steel
bolt in warm water and a little liquid
dish soap.
Installing the milk valve
Insert the stainless-steel bolt from
above.
Insert the silicone seal into the milk-
valve holder.