User manual
H.264 Network Digital Video Recorder User Manual
54
5. Netview and Management
5.1 WEB network control
1
Net connection
Before the WEB operation,need to connect this device with the network.
Note: Some models before in networking, PC must be installed machine tools in CD-ROM package of
the ActiveX plug-in, otherwise IE can not connect
Step 1: Place the device properly access network;
Step 2: Give the host computer and the devices were set IP address, subnet mask and gateway (such as
network routing equipment is not requested the allocation of the IP address of the same network segment, if
the network has routing equipment, you need set up the corresponding gateway and subnet mask), the
device's network settings, please checkmain menu>network settings.
(This device and PC need the same IP network segment. If can’t connect, please check the IP of this device
is connected fluent)
2
Login
After the net connect,then login into.
Step 1: connect the device. Open a web browser, enter the IP address of the login device in the address bar. As
the device with IP address 192.168.1.10 for example, then enter: http://192.168.1.10 in the address bar and
connections.
If the PC connect the device at first time, when open system, the security warning will pop up whether to accept
the WEB control web.cab, please choose to accept the user, the system will automatically identify the installation.
(If the system is prohibited to download, please confirm whether you have other prohibited controls to download
plug-ins, and reduce the IE security level)
Connection as shown below will pop up after the success of the interface.
Note: The first landing, the system will be registered, need to wait for 2 ~ 3 minutes.