User manual

H.264 Network Digital Video Recorder User Manual
20
Picture 3.10 PTZ Control
2

Cruise between Points
Multiple preset points connected cruise lines, call cruise between points, the PTZ run around on the line
1Cruise Between Points Settings
Cruise lines is connected by multiple preset points, setting procedure is as follows:
Step1: In Picture 3.8, the Direction key will turn PTZ to designated location , click Settings button to
enter Picture 3.11,
Step 2: click Cruise buttons, the write proper value into the Cruise Line and Preset Points blankthen
click Add Preset Points button, complete setting (also can add and delete cruise line which has been set up)
Step 3: repeat step1 and step2 , until set out all the preset designated cruise lines
Remove PresetPlease input preset value in the blank, click Remove Preset button, then remove the
preset points.
Remove Cruise LineInput the number of cruise line, click Remove Cruise Lines button, then remove
the cruise lines set
Picture 3.11 Cruise Between Points Settings
2The Calls of Cruise between Points
In Picture 3.8, click Page Shift button, enter PTZ control menu as shown in Picture 3.10. Please input the
number of cruise in the value blank, then click Cruise between Points button, PTZ begins to work on the cruise
line. Click Stop button to stop cruise.
3

Scan
PTZ also can work on the preset scan line repeatedly.
1Scan setup
Step1In Picture 3.8, click Setup button ,enter Picture 3.12
Step2Click Scan buttonthe input proper value in the scan value blank;
Cruise Button
Cruise Line Blank
Preset Points Blank