User manual

H.264 Network Digital Video Recorder User Manual
12
2.8 Speed dome connections
1Connect the 485 lines of the speed dome with the DVR 485 interface.
～
2Connect the video line with the DVR video input.
3Electrify the speed dome.
3. Basic operation
3.1 Turn on
Plug the power supply and turn on the power supply switch. Power supply indicator light shining indicates
turning on the video recorder. After the startup you will hear a beep. The default setting of video output is
multiple-window output mode. If the startup time is within the video setting time, the timing video recording
function will start up automatically. Then the video indicator light of corresponding channel is shining and the
DVR is working normally.
Note:1. Make sure that the input voltage corresponds with the switch of the DVR power supply.
2. Power supply demands: 220V±10% /50Hz-60Hz.
Suggest using the UPS to protect the power supply under allowable conditions.
3.2 Turn off
There are two methods to turn off the DVR. Soft-switchingEntering [right menu]～and choosing [turn off] in
the [turn off the system] option; Hard-switchingPress the power button on the front panel or rear panel power
switch can switch power.
Notice:
1Auto resume after power failure