Specifications

77
7. BULK MEMORY ERASE
STEP PRESS INDICATION COMMENT
1 TIME SET Enter security access code
2 MODE ERASE
3 ENTER
4 CANCEL
The display will show :88 for approx. 5
seconds. The mode will revert to Time
Set with the current time and day
displayed. All user programmed
events will be erased except the
current time, day and date.
Return to normal operation.
8. MEMORY FULL
An attempt to program times and dates in excess of the memory capacity will be indicated on the
Display by a :99. This indication appears with the first program attempt in excess of the memory
capacity.
9. LAMP TEST
The lamp test is a method of turning on all of the front panel indicators except Circuit Status. This
test provides a simple test to indicate proper circuit operation. Press the following front panel
buttons in sequence; (ENTER, BACK, CANCEL & REVIEW). All front panel indicators except
circuit status will illuminate. Press CANCEL, indicators will return to normal condition.
10. DAYLIGHT SAVINGS TIME SELECTION AND 12/24 DISPLAY SELECTION
A special access code is required to set the Baud Rate. The code is a four button sequence
which must be entered in the correct order (ENTER, BACK, CANCEL, DAY).
When the access code is entered, the display will indicate the current status of the daylight
savings time and the 12/24 display. To change the Daylight Savings Time selection use the
AHEAD button.
0: enables Daylight Savings time to the current legislated dates.
1: disables the Daylight Savings Time correction.
To change the 12/24 Display Selection use the BACK button.
:0 12 hour display format
:1 24 hour display format
When the desired selections are indicated, press the ENTER button.
11. BAUD RATE SELECTION
For units equipped with a communications port (RS232 or RS485 Options) the baud rate must be
set. The available baud rate settings are 1200, 2400, 4800 and 9600. The rate set at the Master
Clock must match that of the communicating device.