Installation Instructions

Note: It is highly recommended to have a

licensed contactor preform the installation.

7. Perform a nal test.

8. Apply a thick bead of silicone around the area

where the tub meets the oor. Allow 24 hours for

the silicon to set.

5. Align and connect the tub’s drain to the waste

drain outlet.

6. Remove the masking plastic over the overow

and waste drain covers.

4. Adjust leveling feet if needed to ensure the tub is

completely leveled. If the tub is not properly level

leakage may occure and/or the water will not

completely drain.

1. Remove the tub from it’s crate/box.

2. Make sure to avoid contact with any rough surface.

Ideally, there should be a tarp or cardboard sheet

between the tub and the oor’s surface.

3. Very Important! Before proceeding with installation,

close the waste drain and ll tub with water to test for

leakage. If leakage occures this may be a sign that the

leveling feet are not completely leveled.

One Piece Freestanding Bathtub (Non-Jetted) Freestanding Bathtub

Inspect the box for any damages and then proceed to inspect the bathtub. If any damage is found

please contact us right away

V2.2

or email us at info@MidWestTubs.com

Visit us as www.MidWestTubs.com