Installation Instructions

76
TYPICAL INSTALLATIONS
Make absolutely certain that access panels and/or service openings are properly placed and that all possible areas where
service may be required are accessible.
TUB TO BE SUPPORTED BY THE SUPPORT BASE AND BEDDING, NOT BY THE LIP OF TUB
Note: For caulking, we highly recommend using 100% silicone rather than a latex silicone because it keeps its elasticity and
does not deteriorate.
FOR A QUIETER WHIRLPOOL, WE SUGGEST:
a. Insulate the surround.
b. Set tub in mortar.
SEALANT
TILE
GROUT
SUB-FLOOR
FLASHING
1” x4”
(NOT FOR SUPPORT)
1/8”
MAKE SURE TUB IS LEVEL
TILE
GROUT
FLASHING
1/8”
CLEARANCE
MORTAR/BASE SUPPORT
1” x4”
(NOT FOR SUPPORT)
SEALANT
TUB
INSULATION
MORTAR
1. Pump On/Off:
1st Press - The pump starts.
2nd Press - The pump stops.
2. Light Button:
Touching button controls different
settings.
3. Use Buttons to control up or down
while the blower is running:
1st Press- Press & hold to increase
the blower speed, release
pressure at the desired
speed.
2nd Press- Press & hold to lower the
blower speed, release
pressure at the desired
speed.
4. Blower On/Off:
1st Press-the blower starts.
2nd Press-the blower stops.
Purge Cycle:
There are two different purges: The first at 30
minutes after the tub is used and the second every
24 hours at the time determined by when power is
turned on at the breaker box.
AIR TUB CONTROLS
START UP AND OPERATIONAL INSTRUCTIONS
1
4
2
3
MAGNET
CENTER ACCESS SKIRT
Custom fitted skirt ensembles are available to provide the perfect finish for your bath and bathroom. All five (5) foot and six (6)
foot rectangular models can be fitted with a one or two piece (center access) removable front skirt.
Removable panel held in place by
strong magnets attached to tub and
tub panel and is easily detached for
interior tub access.
INSTALLATION CONTINUEDINSTALLATION CONTINUED