Installation Instructions

PLUMBING ROUGH-IN

The bath waste opening protrudes below the base approx-

imately one inch. You may be required to cut a hole in the

subfloor to accommodate bath waste. In slab on grade or

prestressed concrete floors where cutting is not desired, the

tub may be raised up by building the platform higher and us-

ing extra mortar under the tub. If a joist must be notched,

verify that structure will not be weakened. Remove only what

is necessary. Provide supply pipe, rough-in waste and vent

per code.

PLUMBING

PVC Schedule 40 piping, self draining pump and fittings come

completely preplumbed unless requested otherwise. The

pump and whirlpool system are completely contained within

the tub perimeter. On some models, the pump may exceed

beyond the perimeter of the tub. If you have such a model,

please make allowances during installation.

INCOMING POWER

ELECTRICAL

Factory wired for 110 Volt 20 Amps. Ground Fault Circuit Inter-

rupter (GFCI) is required. The GFCI breaker must not supply

any other circuits or devices.

FINISHING

Before finishing with your choice of material, make sure

access entries are available to the pump, bath waste, and

plumbing fixtures. Finish as desired and seal around tub, pref-

erably with silicone.

NOTE:

1. For Caulking, we recommend 100% sanitary silicone

rather than latex.

2. For quieter operation, you may choose to insulate the

construction area.

3. IT IS THE INSTALLERS RESPONSIBILITY TO SUPPLY

ACCESS TO PUMP AND EQUIPMENT

REMINDER: During construction, we suggest that you cover

tub to avoid use as trash receptacle.

NOTE: To service the pump, blower and other electrical com-

ponents the caulking must be removed. Afterwards the skirt

should be cleaned and caulking reapplied.

Standard GFCI 110V, 20 Amps

Blower Electrical Supply

INSTALLATION CONTINUED