Installation Instructions

4
PREPARE TAIL PIECE
All parts involved in tail piece installation are provide by the installer (figure 5).
10. Drain waste vent must always be installed according to local standard. Verify
the placement of the bathtub before drilling the hole for the drain waste vent.
11. Install 1 1/2 inch rubber slip gasket over the drain waste vent.
12. Cut tail piece to desired length (will vary for each installation).
13. Slide tail piece nut over tail piece towards flanged end.
14. Connect tail piece assembly to waste vent.
15. Place flange washer on top of tail piece.
INSTALLATION CONTINUED
Figure 5