Assembly Instructions

Assemble
10
Concrete Counter tops
Thickness of counter tops are 2”
All forms need to be constructed out of ¾” white melamine using 1½” drywall screws to secure the sides to the bottom piece. Pre-drill
and countersink all holes before fully assembling forms to avoid possible splitting and separating of the melamine material. If any pieces
bubble out, crack, break or show any imperfection, start over with a new piece. Screws should be on the side of the frames when
complete. This will allow for easy extraction when it comes time to remove the concrete from the form. Any inside corners must be cut
at 45 degree angles to continue the melamine material on all edges; exposed wood may bind to concrete, leaving a rough surface, for
around the inside of the frame, use black silicone caulk to apply a nice uniform concave bead to create a smooth radius on the edges of
counter top. Be sure to remove any excess caulk.
Verify all dimension with what is built. The size of you project may very slightly, so please check that all dimensions work. If there are
any discrepancies please make necessary changes. Do not build your frames until your bar is done. This will allow you to get accurate
dimensions for your counter tops.
Refer to the attached manufacturer’s installation instructions for further information.
1’ 4”
1’ 3¼”
1’ 6” 1’ 6”
2’ 1½”
1’ 5”
1’ ¼”
1’ 10”1’ 8½”
1’ 3¼”
2’ 1½”
<120
<120
1’ 10”
1’ 5”
1’ ¼”
1’ 8½”
1’ 8½”
1’ 8½”