Assembly Instructions

Assemble
8
Pond Liner (continued)
Pond Pump
Place the pump in the corner of the basin
near the chiseled block and attach the
pre screen lter to the pump.
(1) Pond Pump
Partially ll the basin with water, allowing for the pond liner to
stretch and conform to the interior of the basin. Check to make
sure the liner is holding water, then ll the basin to the base of the
chiseled area.
Attach the 1¼” tubing to the pond pump. The tubing will need to
extend to the spillway on level 8. For now run the tubing and the
pump power cord through the chiseled groove into the back of the
fountain.
Once the basin has been lled trim the liner to 1½” from the
outside edge of the Belgian Large Wall Blocks.