Installation Instructions

TABLE TOP
ASSEMBLY
TABLE TOP
ASSEMBLY
LEG
ATTACHMENT
LEG
ATTACHMENT
PARTS LIST
STEP 5) Carefully tip table up on at edge as
shown in photo. Do not let table weight rest on a
single leg. Using strict form, lift with your legs and
ip table upright on at surface.
FLIPPING TABLE
UPRIGHT
FLIPPING TABLE
UPRIGHT
STEP 6) OUTSIDE LEGS Align
predrilled holes in bench leg (J), with
predrilled holes in bench (A). Using two
(2) 3/8” x 3-1/2” bolts
(H), four (4) 3/8”
washers (E), and two (2) 3/8” nuts (D),
bolt bench leg to bench. Use two (2)
9/16” wrenches (not included) to tighten
securely. Repeat for other outside leg.
STEP 7) CENTER LEG Align predrilled
holes in bench leg (J), with predrilled holes in center
of bench (A). Using two (2) 3/8” x 4-1/2” bolts (I), four (4)
3/8” washers (E), and two (2) 3/8” nuts (D), bolt bench
leg to bench. Use two (2) 9/16” wrenches (not
included) to tighten securely.
STEP 8) CONNECTING ARM Align predrilled
holes in connecting arm (K), with remaining
predrilled hole in center of bench (A). Using
one (1) 3/8” x 4-1/2” bolts
(I), two (2) 3/8” washers
(E), and one (1) 3/8” nuts (D), bolt connecting arm to
bench. Use two (2) 9/16” wrenches (not included) to
tighten securely [see Image 3].
STEP 9) Repeat steps 6,7 & 8 with the
remaining two (2) benches (A).
BENCH
ASSEMBLY
BENCH
ASSEMBLY
STEP 3) Align predrilled holes in
table leg (C), with remaining predrilled
holes in table top sections. Using two
(2) 3/8” x 3-1/2” bolts (H), four (4) 3/8”
washers
(E), and two (2) 3/8” nuts (D),
bolt table leg to table section. Use two
(2) 9/16” wrenches (not included)
to tighten securely [see Image 2].
STEP 4) Repeat step 3 with
the remaining two (2) table legs (C).
STEP 1) Place all 3 table
sections (B), upside down, on a
smooth at surface. Align sections
so the predrilled holes line up.
STEP 2) Using six (6) 3/8” x 3-1/2”
bolts (H), twelve (12) 3/8” washers (E),
and six(6) 3/8” nuts (D), bolt the table
top sections together. Hand tighten until
all six (6) bolts are in place. Use two (2)
9/16” wrenches (not included) to tighten
securely [see Image 1].
(A)
(B)
(D)(E) (F) (G)(H) (I) (C)
(J) (K)
Image 1
Image 2
Image 3