Assembly Instructions

STEP 15. TRIMS AND SHINGLES
4 Pieces
1×4
Cut to t.
4 Pieces
1×4
Cut to t.
End wall fascia trim to
cover roof sheathing
End wall
corner trim
Raised
½"
1×2
Nailer
1×6 Fascia
Board
1×6 Sot Board
Figure 10
STEP 12. SIDING SIDE WALLS
STEP 13. FASCIA & SOFFIT TRIM
STEP 14. OSB ROOF SHEATHING
Use the appropriate number of 4×8 sheets of sheathing: 6 for a 12' building, 8 for a 16' building,
and 10 for a 20' building. Attach to side wall frames using 6D nails every 8". Raise sheathing 1"
from the bottom of the side-wall frame to prevent moisture absorbing into it. Make certain end
walls and frames are plumb (vertically level) and fasten using 6d nails.
Use the appropriate number of 1×8×8' trim boards for both fascia and
sot: 6 for a 12' building, 8 for a 16' building, and 10 for a 20' building.
Attach fascia to the exposed ends of the roof frame members using 8D
nails. The top edge of the fascia boards should be ½" above the top of the
roof frame member. This will cover the exposed edge of the roof sheathing.
Apply 1×2 nailers against building parallel with the bottom of the frame
overhangs. 1×8 sot boards need to be notched to t between upright
frame members. Attach using 6D nails. See FIgure 10.
• 12' Building: Cut one 4'×8' OSB sheet to 48"×48". Cut
another to two 48"×40½". Cut two more sheets to 96"×40½".
Use two additional full 4'×8' OSB sheets. See FIgure 11.
• 16' Building: Cut four OSB sheets to 96"×40½". Use four
full 4'×8' OSB sheets. See FIgure 11.
• 20' Building: Cut one 4'×8' OSB sheet to 48"×48". Cut
another to two 48"×40½". Cut four more sheets to 96"×40½".
Use four full 4'×8' OSB sheets. See FIgure 11.
Nail roof sheathing in place using 6D nails every 8". Stagger
sheathing end joints from frame to frame where possible.
Cut to t angles for end wall fascia trim from
1×4×8' boards. The tops should be ush with
the roof sheathing, covering the exposed
ends. Tack in place, t, then permanently
nail with 8D nails. From 1×4's, measure, cut,
and attach 8 corner
trim pieces. Place 1×4
trim on sides of the
door opening. From a
1×4×10' piece mark,
cut, and attach trim for
the top of the door area.
Figure 11
96"×40½"
88½"12'
88½"16'
88½"20'
96"×40½" 96"×40½"
96"×40½" 96"×40½"
48"×
40½"
48"×
40½"
96"×48"
96"×48"96"×48"
96"×48" 96"×48"
48"×
48"
48"×
48"
1×4 Corner Trim
Sheet Siding
EZ Frame
Corner
Detail
Apply roof edge and felt. Apply shingles as per instructions printed on bundles.
Door Trim,
cut to t
Corner Trim,
cut to t