Installation Instructions

30
Step 2 - Successive Course Installation for a Concave Curve
Build each course of units by starting at the same place and the same bond as the last course.
Keep in mind, for Concave Curves, the taller the wall the smaller the rst course needs to be. The
radius of each additional course will be slightly larger than the lower course.
To build a Denver SRW with outside corners, two Denver Blocks are required to make one outside
corner. For example, if you need 10 corners to construct a wall, you will need 20 Denver Blocks.
Each corner will require four saw cuts and one split. This process allows for just about any degree of
outside corner.
Center of Curve
Work Left Work Right
Smaller
Radius
Larger
Radius
Additional Courses
DENVER STRAIGHT OUTSIDE CORNER
RETAINING WALLS