Installation Instructions

CLIFTON STRAIGHT
Step 2 - Successive Course Installation for a Concave Curve
Build each course of units by starting at the same place and the same bond as the last course. Keep in
mind, for Concave Curves, the taller the wall the smaller the first course needs to be. The radius of each
additional course will be slightly larger than the lower course.
Center of Curve
Work Left Work Right
Smaller
Radius
Larger
Radius
Additional Courses
90° Corner
90° Corner
90° Corner Flipped
and Turned
1st Course
3rd Course Same
as 1st Course
2nd Course
Step 1 - Base Course Preparation with Corner Block
Using Corner Blocks for outside corners, begin an outside corner from the corner of the wall and install
the blocks from the corner out when possible.
Step 2 - Successive Course Installation
Stagger the Corner Block as each successive course is installed so it is on the opposite side of the wall
corner. This corner unit should be pushed back ¾" to achieve proper setback. Length adjustments to
the Corner Block may be necessary to maintain a running bond. Also, always core fill and glue each cor-
ner unit to ensure proper interlock.
CLIFTON OUTSIDE CORNER