Installation Instructions

DENVER STRAIGHT
Step 2 - Successive Course Installation for a Concave Curve
Build each course of units by starting at the same place and the same bond as the last course. Keep in
mind, for Concave Curves, the taller the wall the smaller the first course needs to be. The radius of each
additional course will be slightly larger than the lower course.
Center of Curve
Work Left Work Right
Smaller
Radius
Larger
Radius
Additional Courses
To build a Denver SRW with outside corners, two Denver Blocks are required to make one outside corner.
For example, if you need 10 corners to construct a wall, you will need 20 Denver Blocks. Each corner will
require four saw cuts and one split. This process allows for just about any degree of outside corner.
DENVER STRAIGHT OUTSIDE CORNER