Installation Instructions

HOLLAND PAVERS

Lay paver stones in desired pattern. If

the desired pattern requires cutting, the

pavers can be cut with a circular saw with a

masonry blade.

Pave Away

You should now be standing before a flat, slightly sloped

expanse of sand. Take down the guide strings you used to

determine height and slope and put up new stakes and strings

to mark the lines for the pattern of you pavers (Image 10).

Start along your house or other long straight edge and lay

down the border pavers. (A border isn’t essential, but adds a

crisp, finished look, especially along curves.) Then lay the rest

of your pavers in your selected pattern. Just lay the pavers

in place- don’t stand on them or twist them. Measure over

to your string every few rows to make sure you’re staying on

track. Tap the pavers tighter together with a rubber mallet.

Midwest Manufacturing pavers have little nubs on the side

to serve as spacers. If you’ve taken the time to set things up

right, laying the pavers will go quickly. Don’t walk or kneel on

the edge of the patio until after you’ve vibrated it; otherwise

these pavers can sink unevenly.

Let pavers run “wild” near the edges of your patio. Using

a paver as a guide, (Image 11) mark the inner pavers,

remove and cut them on a masonry saw, then reinstall the

cut inner piece and the border piece.

On tight radius circles, you can use half pavers for the

border to avoid large, pie-shaped voids between them.

Always wear proper hearing and eye protection while

operating a masonry saw.

Mark pavers that run "wild" into the

border area. Then remove the paver, cut to

size and place back in position along with

border paver.

Cut pavers on masonry saw. Saw has built-

in sliding carriage for moving pavers past

the blade.

Recirculating water keeps blade cool and

lubricated.