Owner`s manual

MIDWEST FASTENERS, INC.

—

CD 50 Stud Welder

CD50 SETUP

After installation, two setup phases must be completed before welding can

begin. These phases are:

• Weld Gun Setup, and

• Controller Adjustment.

Your weld gun setup will depend on your application and the particular

stud to be welded. Setting up the gun consists of the following:

1. Locate the pins (or studs) that were shipped for your job and place a

pin into the weld gun Collet with the “weld tip” protruding. Push this

pin in until it seats firmly, assuring that the flange (or collar) of the

weld end does not come into contact with the collet.

2. Make sure that the gun “setup” accessories that came with the CD 2

weld gun are adjusted properly and fastened tightly. Illustrations on

the following pages for:

• Insulation Pins (Figure 1)

• Insulation Pins with Collet Protector (Figure 2)

• Insulation Pins with Internal Stop (Figure 3)

•Weld Studs (Figure 4)

NOTE: These components may need to be readjusted, or changed, as

your job requirements change.

WELD GUN SETUP