Product specifications

C.A.R.T. FURY 13
C
HAPTER
3 S
ERVICE
To service Dollar Bill Validator, continued…
• Unlock the coin door and swing it open. Read the label affixed to the door for additional information.
• Disassemble the validator and remove material to permit it to fit inside the coin door as illustrated then
reassemble unit.
D
OLLAR
B
ILL
V
ALIDATOR
S
ERVICE
To service PCB Board Assemblies…
• Switch off the power to the game machine and unplug the AC line cord.
• Unlock and remove the rear door.
• Remove the screws used to fasten the hinged, metal cage covering the PCB Assembly.
• Open the cover, which is hinged along the bottom edge, to expose the PCB assembly.
• Carefully note the orientation of the JAMMA connector and the other cables. Extract the harness and
other cables from the board connectors.
• Remove the mounting screws from the desired circuit board assembly. Lift the board out of the cabinet
and set in a safe place. Use anti-static bags and protective containers from new parts for storage if not
reinstalled immediately.
• Perform the desired repair or equipment replacement.
• Be certain to reinstall the perforated cover so that it seals against the metal plate.
To service Wheel Driver Board Assembly…
• Switch off the power to the game machine and unplug the AC line cord.
• Unlock and remove the rear door.
• Remove the screws used to fasten the hinged, perforated metal cage covering the PCB Assembly.
• Open the cage, which is hinged along the bottom edge, to expose the PCB assembly.
• Carefully note the orientation of the cables. Extract the harness and other cables from the board con-
nectors.
CAUTION
Discharge any static electricity built up in your body by touching the chassis for the
power supply. Do this BEFORE touching or handling the electronic assemblies.