Product specifications

12 M
IDWAY
A
MUSEMENT
G
AMES
, LLC
C
HAPTER
3 S
ERVICE
To service Boost Buttons on the Steering Wheel Hoop, continued…
• Unscrew the nut on the button. Lift the button out of the steering wheel hoop.
• Perform the desired repair or equipment replacement.
• Be sure to solder the cable wires to the button’s switch when reinstalling a button(s).
• Reinstall and fasten all items in place with the screws provided.
To service Control Cabinet Speaker…
This speaker is located just above the pedal assembly.
• Switch off the power to the game machine and unplug the AC line cord.
• Remove the Control Cabinet. Refer to service instructions for Control Cabinet.
• Label and disconnect wiring, including the ground strap.
• Remove the nuts on the mounting screws before removing the speaker from the enclosure.
• Perform the desired repair or equipment replacement.
• Carefully reseat the seals upon completing any task in the speaker enclosure.
• Reconnect the wires, including ground. Refer to the Cabinet Wiring Diagram for correct speaker polarity.
To service Pedal Assembly…
• Switch off the power to the game machine and unplug the AC line cord.
• Remove the Control Cabinet. Refer to service instructions for Control Cabinet.
• Adjust the seat to the maximum rear position.
• Remove 4 tamper resistant screws used to fasten the Pedal assembly to the cabinet.
NOTE:
Due to the
weight of the pedal assembly it may slide or abruptly jerk out of the opening once all screws are loos-
ened and/or removed.
• Pull the assembly forward enough to expose wiring.
• Carefully note the orientation of the cable wiring. Label and disconnect wiring, including ground.
• Perform the desired repair or equipment replacement.
• Reinstall pedal assembly and reconnect wiring, including ground.
• Align the holes for the screws and fasten in place with the hardware provided.
To service Coin Meter…
• Switch off the power to the game machine and unplug the AC line cord.
• Unlock the cash door and swing it open. Remove the cash tubs.
• The meter is located on a plate at the vault bottom. Remove the screws and lift the plate just enough to
disconnect the meter wires from the harness.
• Record the meter count before testing or replacement.
• Perform the desired repair or equipment replacement.
To service Coin Mechanism…
• Switch off the power to the game machine and unplug the AC line cord.
• Unlock the coin door and swing it open.
• Unlatch and remove each coin mechanism separately to clean or replace with a different type. Ensure
mechanism seats fully in the holder upon reinstallation.
• Close and lock the release latch, then close the door.
• Turn on the game and change the mechanism setup, then test known good and bad coins to verify oper-
ation.
To service Dollar Bill Validator…
(Use MARS AE2411-U3 UL recognized currency changer)
Dollar bill validators or other currency acceptors may be installed in games that are manufactured with the
additional wiring connector.
• Switch off the power to the game machine and unplug the AC line cord.