Product specifications

C.A.R.T. FURY 7
C
HAPTER
1 O
PERATION
7. Roll the pedestal section near the control cabinet, leaving enough space to attach the wiring harness.
Mate cables between the pedestal and the control cabinet. Press firmly, but do not force, the keyed
connectors to seat the contacts. Ensure no wires are pinched during pedestal attachment.
8. Align the opening in the pedestal with the ends of the rails. Slide the pedestal forward onto extended
mounting rails and align the holes. Attach pedestal assembly using 1/4-20 tamper resistant screws
and large flat washers. A T27 wrench is included with the spare parts to tighten these screws firmly.
Tighten the hex head bolts after the tamper resistant screws have been tightened.
LOCATION OF PEDESTAL ASSEMBLY MOUNTING HOLES
9. Lower and adjust each leg leveler until the pedestal section is stable and level. Adjust the levelers until
the bottoms of all pieces are flush and parallel with each other. Inspect for binding or pinched wires.
Insert and firmly tighten the remaining fasteners to attach the two pieces together as a single unit.
10. An extra padlock may be installed to secure the rear door. A hasp is located in the spare parts bag.
Remove the two lock bracket nuts from inside the cabinet, above the rear door opening. Slide the
hasp bracket onto the bolts so that it protrudes from the hole in back of the cabinet, then reinstall nuts.
11. Modify the lock plate at the top of the rear door. Remove the bolts and nuts from the lock plate, then
rotate the plate so that the slot will be above the door. Reinstall the bolts and nuts and tighten firmly.
REAR HASP INSTALLATION