User guide

midon design
1WSwitch User Guide Version 1.02 Page 12 of 28
Command
Description
Syntax
on to off or from off to on number corresponding to the
DS2405 sensor number as
shown in the DIS display
VER
Displays the current version of the
software loaded
VER
ZZZ
Performs a soft reset of 1WSwitch ZZZ
Notes
1. The <sensorid> parameter in the commands above refers to the sensor number as
shown via the DIS command. Leading zeros are required. See the DIS command
explanation below.
2. Most commands do not require a Carriage Return (enter) following the parameter
or command input. One exception is the SCK command. Commands requiring a
sensor number input will require a CR if the sensor number is only a single digit.
3. Command parameters are shown in angled brackets “< >”. Where only certain
options are permitted, they are indicated with a vertical pipe character “|”.
6.1. Using the SET Command
The SET command has multiple parameters. All option parameters are also
adjustable via discrete commands.
>set
Poll interval = 01
Serial # Display = on
Time Display = off
OnBoard ADC Display = on
Enable INP = off
Debug = off
Set Clock (d,h,m,s): 01,14,30,00
Poll Interval
This parameter determines the time between sensor readings. Set to 00
to stop polling. Enter the time in decimal minutes. Use the SPT command to
adjust only this parameter.
Serial # Display
Set this to On if you want 1WSwitch to display the 1-wire ID of all sensors.
Use the SID command to adjust only this parameter.
Time Display
Set this to On if you want 1WSwitch to display the voltage as measured at
connector J2 pin 3. Use the DAD command to adjust only this parameter.