User guide

midon design
1WSwitch User Guide Version 1.02 Page 11 of 28
Command
Description
Syntax
MEM
Display and change specific memory
locations
MEM <start location><cr>
ONA
Turn ON a DS2406 or DS2407
(channel A only)
ONA <sensorid>
Where xx is a decimal number
corresponding to the DS2406/7
sensor number as shown in the
DIS display
OFA
Turn OFF a DS2406 or DS2407
(channel A only)
OFA <sensorid>
Where <sensorid> is a decimal
number corresponding to the
DS2406/7 sensor number as
shown in the DIS display
RLY
Actuate a specific 1WIO relay
RLY <relay number> <on|off>
Where <relay number> = 01 to
80 or A for All (the leading zero is
required for relay numbers less
than 10)
SCK
Set Clock SCK dd, hh, mm, ss<cr>
dd = 01 to 07 (Sunday = 01)
hh = 00 to 23
mm = 00 to 59
ss = 00 to 59
Note 2
SET
Configure all system parameters
SET
SID
Show the Serial Number ID for the 1-
Wire Devices
SID <on|off>
SPT
Set the polling interval in minutes SPT <xx>
Where <xx> is a decimal number
from 00 to 99. 00 will disable
polling.
TIM
Display Time from the Real Time Clock TIM
TMP
Display sensor readings of all
connected 1-Wire Devices in either
verbose (includes serial numbers) or
non-verbose mode
TMP
TOG
TOGgle a DS2405 sensor output from
TOG <sensorid>
Where <sensorid> is a decimal