User guide

midon design
1WSwitch User Guide Version 1.02 Page 10 of 28
6. 1WSwitch Commands
Table 1 1WSwitch Command List
Command Description
Syntax
DAD
Display on-board ADC voltage during
poll output
DAD<on|off>
Note 3
DEB
Enable or disable debug outputs
Use only when directed to by Midon
Design
DEB<on|off>
DEL
Delete a sensor that was previously
installed via the INI command
DEL<sensorid>
Note 1
DIS
Display serial numbers of all registered
1-Wire devices
DIS
DTI
Display Time every minute
DTI<on|off>
EEP
Display and change specific EEPROM
memory locations
EEP <start location><cr>
EIN
Enable polling of 1WIO sensors for
input status
EIN<on|off>
ERA
Erase the entire EEPROM
ERA
HLP
Display a list of available commands
HLP
INI
Register all connected 1-Wire sensors
INI
INP
Display the status of bits 4-7 of the first
connected DS2408
INP
LED
Actuate a specific LED on a 1WIO LED
unit or an equivalent DS2408 LED
interface
LED <LED number> <on|off>
Where <LED number> = 01 to 80
or A for All (the leading zero is
required for LED numbers less
than 10)