User guide

midon design
TEMP08 User Guide Version 4.0x Page 16 of 25
Rain #01[8E00000001562C1D]=003.32 Inch
Counter #01[D4000000045C621D]=00000029 00024592
1WIO Status #01 [A400000001042829] = On,Off,On,Off
Temp #01[9900080049199310]=79.80F
Temp #02[5C00080009242E10]=75.80F
Temp #03[9F00000037555326]=79.00F
Temp #04[A900000037621A26]=78.77F
Temp #05[21000000032E4E22]=???
Temp #06[020000002B2CB326]=76.10F
>
The output starts with a time reading, followed by humidity, barometer, voltage,
wind direction, wind speed, counter readings, 1WIO input status, and ends with
all temperature sensors. All DS2438 temperature readings will be displayed in
addition to the other temperature sensors, only if the ETD option has been set to
On.
Note that in the example above, Temperature sensor #5 shows “???” which
indicates that this sensor was not detected during the poll.
Humidity readings are displayed in percent Relative Humidity.
Barometric pressure sensors are displayed in Inches of Mercury.
The first voltage reading displayed for a DS2438 Voltage sensor is always the
external voltage from the DS2438 input. This is followed by the VDD (supply)
voltage and lastly by the voltage from the on-board current sensor. Changing a
humidity or barometric sensor type to a voltage type may be useful for trouble-
shooting problems with a sensor.
Voltage readings for any DS2450 sensors are displayed after any DS2438
voltage sensors. All four channels of voltage input for DS2450’s are displayed, A
channel first, ending with D channel.
Wind direction is expressed via the 16 cardinal points of the compass:
N
NNE
NE
ENE
E
ESE
SE
SSE
S
SSW
SW
WSW
W
WNW