User guide
midon design
TEMP08 User Guide Version 4.0x Page 15 of 25
The letters designate the sensor type per the following table.
Table 2 Sensor Type Descriptions
Following a display of the sensors installed, the output of the DIS display then
shows the TEMP08 settings that you entered via the SET command.
5.3. TMP Output Display
The TMP output and polled output displays are identical. An example is shown
below.
>
WED 21:51:13
Reading Sensors...
Humidity #01[9F00000037555326]=60%
Barometer #01[A900000037621A26]=28.21 inHg
Voltage #01[020000002B2CB326]=02.60V 05.03V 01mV
Voltage #02[0100000001096420]= 02.50V,03.00V,01.02V,05.01V
Wind Dirn[9F00000001087320]= NNW
Wind Speed[8E00000001562C1D]=00 MPH, Gust = 00
Designation
Description
1-Wire Device
B
Barometric Sensor
DS2438
C
Generic Counter Sensor
DS2423
H
Humidity Sensor
DS2438
I Input 1WIO DS2408
L LED 1WIO DS2408
O Output (Relay) 1WIO DS2408
R
Rain Sensor
DS2423
T Temperature only from DS2438 DS2438
V
Voltage Sensor
DS2438
W
Wind Speed Sensor
DS2423
? TYPe has not been set Any