User guide

midon design
TEMP08 User Guide Version 4.0x Page 12 of 25
Command Description
Syntax
ZZZ
Performs a soft reset of TEMP08 ZZZ
Notes
1. The <sensorid> parameter in some commands above refers to the sensor number
as shown via the DIS command. See the DIS command explanation below.
2. Most commands do not require a Carriage Return (enter) following the parameter
or command input. One exception is the SCK command. Commands requiring a
sensor number input will require a CR if the sensor number is only a single digit.
3. Command parameters are shown in angled brackets “< >”. Where only certain
options are permitted, they are indicated with a vertical pipe character “|”.
5.1. Using the SET Command
The SET command has multiple parameters. All parameters are also adjustable
via discrete commands.
Update Interval
This parameter determines the time between sensor readings. Set this
parameter to 00 to stop polling. Enter the time in decimal minutes. Use the SPT
command to adjust only this parameter.
Temp Display
This parameter determines how temperature readings are displayed. Enter F for
Fahrenheit or C for Celsius. Use the STD command to adjust only this
parameter.
Serial # Display
Set this to On if you want TEMP08 to display the 1-wire ID of all sensors during
the DIS display or poll display. Use the SID command to adjust only this
parameter.
Wind Dirn Reverse (Wind Direction Reverse)
This parameter is normally set to Off. Set this to On if you accidentally installed
the wind direction PCB upside down in your weather station OR if you want to
display wind direction as the FROM direction instead of the TO direction. Use the
WDR command to adjust only this parameter.
DS2438 Temp Display