User guide

midon design
TEMP08 User Guide Version 4.0x Page 10 of 25
5. TEMP08 Commands
These commands are valid for v4.0x versions of TEMP08 software.
Table 1 TEMP08 Command List
Command Description
Syntax
DEL
Delete a sensor that was previously installed
via the INI command
DEL<sensorid>
Note 1
DIS
Display serial numbers of all configured 1-
Wire devices
DIS
ERA
Erase the EEPROM
ERA
ETE
Enable Temperature displays from DS2438
devices
ETE<on|off>
ETI
Enable Once-Per-Minute Time Display
ETI<on|off>
EWN
Enable Wind Direction display for DS2450
sensors
EWN<on|off>
FAC
Restore to factory settings. Erase the
EEPROM, reset the clock to 00:00, and
perform an INI function. USE WITH
CAUTION.
FAC
HLP
Display a list of available commands
HLP
INI
Search for a list of available 1-Wire sensors.
INI
INP
Display the status of bits 4-7 of all connected
DS2408’s (See 1WIO sensor for details)
configured as TYPe “I”
INP
LED
Actuate a specific LED on a 1WIO LED unit
or equivalent DS2408 LED interface
configured as TYPe “L”
LED <LED number> <on|off>
Where <LED number> = 01 to
80 or A for All (the leading zero
is required for LED numbers
less than 10)