Instruction Manual

1 7 | Page
MNECSW E-Panel Instructions
1 0-262-1 REV E
Installation
Tools Required:
Drill and drill bits for pilot holes
#2 Phillips screwdriver
Slotted screwdriver (A torque driver is recommended for all electrical connections)
Wrench or socket set for mounting
Wrench or socket set for DC Terminals
Wire strippers
Needle-nose pliers
Other materials needed for installation:
(these will vary based on system options)
Strain Reliefs,
Hardware for Mounting E-Panel, Inverter and Backplate
Wire/cable for AC and DC connections
Optional equipment and materials:
Classic Charge Controller,
The KID Charge Controller,
Conduit, conduit nipples and fittings
Dinrail or panel mount circuit breakers -
MNSPD Surge Suppressors
Slider Kit - MNSW-SLIDER-30 or MNSW-SLIDER-50 - Ties breakers together for use as an AC bypass
MNBDM Battery Disconnect Module
Whiz Bang Jr for enhanced system monitoring (Requires The KID or Classic Charge Controller)
Accessories / Replacement parts
Should you require any accessories or replacement parts please visit www.midnitesolar.com and follow
the link to products.