Installation Manual

MNPVHV Disco Instructions (continued)
30 | P a g e 1 0 - 065- 1 R E V : F
MNPV8HVMCM300 Adaptor Kit
The MNPV8HVMCM300 adaptor kit is available for the MNPV8HV to allow the use of
larger output wires, up to 300 MCM. If required, new units ship with this kit installed.
Negative Output Lug
MNPV8HVMCM300 Adaptor Kit
Penny shown for reference of scale
Step 1:
Install Box Lugs onto busbars as shown.
Step 2:
Remove white plastic cover from
the negative output Busbar. Loosen
two outer (large) screws. Position
Busbar and Lug assembly into
Negative output terminal busbar.
Step 2A:
Tighten Busbar and Lug assembly.
Replace White Plastic cover. Refer to
torque chart on page 4.
Positive Output Lug
Box Lugs
Negative Busbar
Positive Busbar