Installation Manual

MNPVHV Disco Instructions (continued)
26 | P a g e 1 0 - 065- 1 R E V : F
Installing the MNDiscoPSB Power Supply PCB: Continued
Step 1: Remove the top cover and deadfront (Page 3).
Step 2: Remove plastic supports (2)
by removing screws from the back
side of the combiner. Set aside to
reinstall later.
Step 3: Place the Formex insulator as
shown.
Step 4: Install metal standoffs (2) and
Reinstall plastic PCB supports
removed in Step 1 (2).