KID Manual Firmware 1797 REV D

38 | Page
1 0-268-1 REV D
The Kid Solar Charge Controller Instructions
that the number is set the unit will click more frequently, and may turn on sooner (with less power
available). If you do not understand this setting, do not change from the factory default setting (8.0),
unless instructed from MidNite Solar personal Tech Support.
To adjust the settings:
*Press Menu Back
*Scroll to the right then select TECH and press Enter
*Select Calibrate and press Enter
*Press the right arrow until AntiClick Sensitivity is on the top line of the LCD
*Use the Up and Down buttons to adjust to the desired setting
*Press the SAVE button to keep the settings.
EndAmp Shunt Sel: - Selects between The Kid's internal shunt and the (optional) WBJr's shunt.
To adjust the settings:
*Press Menu Back
*Scroll to the right then select TECH and press Enter
*Select Calibrate and press Enter
*Press the right arrow until EndAmp Shunt Sel is on the top line of the LCD
*Use the Up and Down buttons to adjust to the desired setting
*Press the SAVE button to keep the settings.
Pre Matching:
To adjust the settings:
*Press Menu Back
*Scroll to the right then select TECH and press Enter
*Select Calibrate and press Enter
*Press the right arrow until Pre Matching is on the top line of the LCD
*Use the Up and Down buttons to adjust to the desired setting
*Press the SAVE button to keep the settings.
Do not adjust this setting unless directed to do so by MidNite Solar Tech Support.
Min Low Power:
To adjust the settings:
*Press Menu Back
*Scroll to the right then select TECH and press Enter
*Select Calibrate and press Enter
*Press the right arrow until Min Low Power is on the top line of the LCD
*Use the Up and Down buttons to adjust to the desired setting
*Press the SAVE button to keep the settings.
NightLight on PV: This setting is for adjusting The Kid's sensitivity to ambient light.
In the event that your night lights shine on the panels this setting adjusts the threshold of light required to