KID Manual Firmware 1797 REV D

1 3 | Page
1 0-268-1 REV D
The Kid Solar Charge Controller Instructions
+ - + -+ -
The Kid Terminal Block
PV Input
Load
Battery Out
The Kid Main Electrical Connections
The following pages contain wiring diagrams and system images.
Remove the back cover .
Remove the screw on the middle right of the back cover and gently remove the back cover.
The connections for PV input, Load and Battery out are available on the terminal block shown below,
located inside The Kid on the backside of the circuit board.
Observe polarity on all connections.
PV Input : Connections from the solar panels go here.
Load : Connections to the controlled load (load control function).
Battery Out: Connections to the battery bank go here.
Torque all connections to 7-9 inch pounds (0.80 - 1 .0 Nm).
Input and output negatives must be isolated for proper operation.
Rear View of The Kid with the back cover removed.
Use 75°C Minimum rated copper conductors.
Utiliser uniquement avec conducteurs de cuivre nominale minimale de 75° C