Kid Manual

The KID Solar Charge Controller Instructions

Sticker Placement

Due to the large number of required warnings it is easy to begin to overlook them.

Some of the warnings are actually quite important and good knowledge for the installer and user.

All required labels are supplied. You will find a label identifier on the previous page.

The placement guide below shows where each label goes. Please take the time to read and

understand each label as you place it on the unit.

These warning labels are Required by the regulatory standards that The KID has been

tested to. Place the stickers where shown. Some Stickers will be applied at the factory.

Some are internal and number 5 will be on the shipping box.

Battery Type Sticker

Fuse Sticker*

Rain Warning Sticker

Cautions Sticker*

Connection Sticker

Voltage Sticker

Ignition Sticker

Ground Sticker

Do Not Overtighten

Spark Warning Sticker

Model / Serial Number Sticker*

* Pre-Installed

Shock Sticker

Serial/Model number sticker may be on the wall mount adaptor on some units.

8 | Page 1 0-268-1 REV T