Kid Manual

The KID Solar Charge Controller Instructions
Aux input/output wiring:
This 3 position terminal block is the aux input/output. Functions such as Auto Gen Start, Low Battery
Disconnect or the WhizBang Jr are connected here.
As new firmware features are added they will be available
at http://www.midnitesolar.com/firmwareIndex.php
AUX +
AUX -
WBJR
Small Terminal Block
The top position is AUX +.
The middle position is AUX -.
See page 39.
The bottom position is where
the purple wire from the WBJr.
is connected (Optional).
See pages 1 9, 38, 41 , 44, 55, 59.
Do not allow excess
exposed wire
Stacking port
Battery temperature
sensor (BTS) port
Sample wiring showing PV, Load, Battery, Whizbang Jr., BTS, and stacking cable.
Wires may exit through either conduit fitting.
Important!
The input and output negative
connections must remain isolated.
Failure to do so will cause
inaccurate current readings and
possible damage to the unit.
Load Positive is internally connected
to Battery Positive. Loads are
switched in the negative leg.
One Heyco part # M3200 One Heyco part # UB-875
strain relief is supplied for bushing is supplied for
the power connections. other connections.
1 8 | Page 1 0-268-1 REV T