E-Panels Explained

The Magnum Energy 240VAC E-Panel for PAE series

This is our flagship E-Panel. It accommodates the Magnum Energy MS4448-PAE and MS4024-PAE

inverters. These inverters are a true 120/240 input and output. Unlike the regular Magnum MS and

RD series that have a second 120VAC pass through leg, these inverters are like having a stacked

pair of inverters. It will charge from either a 120VAC source or a 240VAC source.

The output is 120/240 just like the utility grid. Compare this system with a stacked pair of 120VAC

inverters (from any company) and you will realize thousands of dollars of savings! The Magnum

240VAC E-Panel uses a white steel chassis to match the MS series. It has black and red AC input

and output terminal bus bars, red terminal bus bars for PV+ and Bat+, six additional din rail slots,

500A shunt, ground busbar, remote bracket, wall mount brackets, inverter cables, charge control

mounting bracket, 120/240 AC bypass switch pre-wired and a 120/240 AC input disconnect pre-

wired.

Outback AL PLUS and STS Models

These E-Panels come standard with the AC bypass and AC

input disconnect pre-wired into the box. It has din-rails for six

additional 13mm wide AC or DC breakers along with a

battery breaker installed with inverter plus and minus

cables. There is a 500 amp/50mV shunt, a battery plus

busbar plus a number of features included: battery minus

busbar, AC busbars, ground busbar, DC cover, AC flex

conduit tubing with couplers, MX60/Classic mounting

bracket, grommets and bushings, numerous knock outs for

cable entry and exit, lots of hardware for mounting inverter,

charge controller etc., wall mounting brackets, installation

instructions, wiring diagram mounted on the door.

All AL PLUS models are white aluminum and are used in

places like Hawaii or Maine or wherever salt air is a factor. Aluminum E-Panels also weigh 9 pounds

less than the STS gray powder coated steel versions. These models can be purchased in right hand

versions.

Schneider Conext SW and XW E-Panels

The Conext SW E-Panels are perfect for off-grid, backup power and

self-consumption applications. They are made for a single Schneider

Electric Conext SW inverter/charger. The SW inverter is mounted

directly to the right of the E-Panel. The Conext SW’s are available with

the 175 amp breaker (MNE175SW) for the SW2524 inverter or with

the 250 amp breaker (MNE250SW) for the SW4024 inverter. The

MNE175SW or MNE250SW features inverter battery breaker,

knockouts for up to 6 din rail mount AC or DC breakers (or the

optional Bypass Kit) and 4 panel mount or DC-GFP80 breakers.

Massive tin plated copper bus bars directly connect to the SW’s

battery terminals, bus bars for AC inputs, AC output, neutral, ground,

PV + in, PV- in, Bat +, Bat-, 500 amp shunt, Location to mount two

charge controllers to the top. There are knockouts that correspond to

the 1 inch knock outs in the charge controller. The Conext XW E-

Panels are perfect for grid-tie and AC coupled applications.

MNE250XWP-SINGLE