E-Panels Explained

3
The Conext XWs feature:
 Inverter battery breaker
 2 separate 60 amp AC inputs for generator and utility
 60 amp AC bypass switch
 Knockouts for up to seven din rail mount DC DCGFP63 or AC breakers and 12 panel mount
or DC-GFP80 breakers
 Massive tin plated copper bus bars directly connect to the XW’s battery terminals
 Bus bars for AC inputs
 AC output neutral, ground, PV + in, PV- in, Bat +, Bat-
 500 amp shunt (MNSHUNT)
 Metal dead front behind the reversible door
 Charge controllers mount to either side or both sides at once for dual controllers
 AC bypass can be configured as input & output on/off as well as AC bypass.(Note: The XW 60
amp controller can mount on the Right side only due to their isolated communications
compartment)
 The XW MPPT controller requires no mounting bracket. FM60, FM80 and Classic require
Right or Left E-Panel charge control mounting brackets. Right hand bracket furnished
standard.
 Main Breaker Current Rating – 175 and 250
 Number of breaker spaces - 19
 Environmental Rating - Type 1 (Indoor)
 Max. Wire Size - 4/0 AWG
 Max. AC Voltage - 240VAC
 Max. DC Voltage - 300VDC
 Warranty - 5 yrs.
 Listed by ETL for US & Canada
 Made in the USA
SMA E-Panels
MNE250SMA-AC-SINGLE Master E-Panel is for a single Sunny Island AC Coupled system. (MidNite
Autoformer and SunnyBoy inverter required)
The MNE250SMA-AC SINGLE Master includes the
input/output 60amp, 120/240vac bypass system
along with separate 60 amp, 120/240vac AC input
and output breakers. This E-Panel comes with a
250amp remote trip battery disconnect breaker
and inverter cables. Pre-wired with AC input and
output wiring.
RS485 boards are required when AC Coupling to
SunnyBoy inverters if 3 stage charging is desired.
One RS485 board goes into the Sunny Island
inverter and each SunnyBoy Inverter. AC Coupling to the SunnyBoy grid-tie inverter is possible
without RS485 boards. The Sunny Island grid-tie inverter will frequency shift based on battery
voltage to knock the grid-tie inverter off line. SunnyBoy inverters can switch between off-grid and
grid-tie mode automatically when RS485 boards are used. To program this feature you must use
either a SMA service cable (USBPBS) or SMA web box (SUNNYWEBBOXU).
MNE250SMA-AC-SINGLE Master