MNDC Instruction Manual

MNDC Instructions (continued)
7 | P a g e 1 0 - 0 06- 1 R E V : C
DC Breakers and Cover
MNDC uses for various different inverter installations.
Remove the DC breaker
cover to install din rail
mount breakers. Insure
the yellow tab snaps
into place to secure the
breakers. Strip wires
3/8” and bend at ¾”
from end. This section is
very tight so pay close
attention to wire
routing. Use cable ties
to secure wires in a
neatly routed bundle.
Lay the cover plate on a
flat scrap wood surface
and using a flat screw
driver blade and
hammer cut the tabs.