DIY Manual

61 | P a g e 10-543-1 REV A
DIY Manual
5. Depress Main Menu button to return to previous AUX Menu page
6. Use up/down arrows to ensure WIZBANG JUNIOR reads below the header AUX 2
7. Depress Enter button to save changes
Charge Menu
1. Using arrow buttons, highlight Advanced sub-menu, depress Enter button
2. Set Ending Amps based on bank’s amp-hour capacity per battery manufacturer’s
guidance. Without guidance, 1% - 3% of total amp-hour capacity is common.
3. Depress Left Soft Key so that SHUNT reads below Ending Amps on MNGP.
4. Depress Enter button to save changes. Now the Classic will read current off the
external shunt vice its internal shunt.
KID Charge Controller Settings
AUX Menu
1. Depress Menu Back button, then scroll to AUX, depress Enter button
2. Use up/down arrows till WBJR reads to the right of FUNC
3. Move asterisk to left side of AUTO
4. Depress Setup button
5. Enter battery bank amp-hour capacity, depress right arrow
6. Enter bank efficiency %, depress right arrow
7. Enter reference temp, depress right arrow
8. Enter capacity percent change per battery manufacturer, commonly 0.5% to 1.0%
9. Depress Save button
TECH Menu
1. Depress Menu Back button, scroll to TECH, depress Enter button
2. With asterisk to the left of CALIBRATION, depress Enter button
3. Depress right arrow two times
4. Use up/down arrows till WBJR shows
5. Depress Save button
BATTERY Menu
1. Depress Menu Back button, then scroll to BATTERY, depress Enter button
2. Use arrow buttons to move asterisk to left side of TCOMP, then depress right arrow
3. Move asterisk to left side of Advanced, depress Enter button
4. Set End Amps as recommended by battery manufacturer, commonly 1-3% of Ah
capacity, 20-Hr rating.