Installation Guide

Classic owner’s manual Rev I 2193
66 |
P a g e 1 0 - 0 0 1 - 1 R E V : I
mixed up my covers
how do I know what
model Classic I have?
on the left side of the circuit board
*You can press the status button several times and the Classic will say
―Connected to Classic xxx‖ on one of them, this is your model #
I can’t read my serial #
sticker how can I find
my serial #
*Press the status button several times and a screen will come up saying
―Connected to a Classic xxx‖ in the bottom right corner is the serial number, it
will start with a CL.
How do I know what
Nominal voltage my
Classic is programmed
for?
*Press the status button several times and a screen will come up saying
―Connected to a Classic xxx‖ to the right of this it will say the battery voltage
it is programmed to (Example 48v)
I have Aux1
programmed properly
but I cannot get 12v out
of it when I should?
*Most likely the Jumpers on the bottom left corner of the circuit board are set
for a dry relay not for a 12v signal. See the Aux portion of the manual for help
with that.
I was in the middle of a
firmware update and the
update got interrupted
what do I do?
*No problem simply start over with the update, The Classic has a boot loader
that will always look for new firmware on boot up so you cannot damage the
Classic.
Can I use wind and
Solar on a single
Classic?
*No they both require drastically different tracking algorithms so you will need
two Classics
Can I have more than
one Classic on a single
battery?
*Yes as long as they have separate Solar Arrays
Do I have to shut off my
Classic if I have a
different charger
charging?
*No the Classic will work just fine in conjunction with ANY other charger on
the same battery