Installation Guide

Classic owner’s manual Rev I 2193
55 |
P a g e 1 0 - 0 0 1 - 1 R E V : I
Connecting the Classic to the Internet
Networking
The Classic supports standard 10/100-base T Ethernet networks. For Gigabit networks you will need a
common network switch that is capable of mixed mode operation. The Classic may also be placed on a, b,
g, or n wireless networks by using a wireless network bridge device.
Depending on your network you may use one of the topographies detailed in Example 1 through 4 below.
Note that the switch may be self-contained or, in many cases, may already be integrated into your cable or
DSL modem. Refer to Figure 30 for Ethernet connector location in the Classic.
4-Port Switch /
Router
Example 1 Local network through switch. In some cases you may be able to connect Classic directly to your PC; however, this
is not a recommended topography.
Wireless Router/
Access Point
Wireless
Bridge
Wireless Router/
Access Point
Wireless enabled
computer
Example 3 Local wireless network
Example 2 Local network through wireless bridge.