Installation Guide

Classic owner’s manual Rev I 2193
49 |
P a g e 1 0 - 0 0 1 - 1 R E V : I
that the time stamp above the word TIME is the time, shown in 24 hour format, that the data was captured that day.
The category of data captured is of course more suited for minute by minute capture rather than the maximum data
statistics captured on a day by day basis in the DAILY log screen. The left side of the recent history text log screen
can be individually viewed by selecting the left side and pressing the UP/DOWN arrow keys to show the power,
voltages, charge stage etc. and various information captured at the time shown on the right side time selection.
Screenshot 5
At the bottom of the DAILY text log screen, the TIME the maximum statistics were stored is shown,
whereas at the bottom of the HOURLY text log screen, the DATE of the capture is shown. Again, if for
some reason the year of the time stamp was less than 2011, the time/date will alternate between INVALID
and the time/date stamped along with that data and does not necessarily mean the data itself is not correct.
If the data is all zeros and the year is shown as 2000, the data IS most likely invalid and not correct or the
logging memory has not been filled yet. This is why the Classic powers up with the year 05/04/2003... It
means that data was actually logged but the date was not set, whereas if it is showing 00/00/2000 it will
normally mean that the data is just zero and therefore invalid data as well as invalid time and date.
The upper right corner of the text log screens displays a number from 1 to 380. This number shows the
index or position of the data in the 380 data log time slots. The most recently stored data has an index of
1. Two data points ago shows an index of 2, etc. This index goes for either Daily History or Recent
History text log viewing screen.